San RamonAh slurry pumpCorrosion resistance is an effective way

　　 drainage and water injection with vacuum equipment: the self exhaust of centrifugal pump is the same as the negative pressure exhaust of vacuum pump, so the water ring vacuum pump is used for exhaust to achieve the of water inlet.　　 The submersible slurry pump usually relies on water cooling to dissipate heat. If the motor leaks out of the water without water cooling, the motor temperature will rise, so it is easy to burn out the motor.San Ramon　　Operation management of screw pump Nemo pump (single screw pump) is a positive displacement pump, which is widely used in sewage plant to transport sludge and chemicals containing solid particles.　　 The working properties of the two pumps are also different. Because the sewage pump is driven by a motor, it generally has good voltage impact resistance. The submersible pump is of the type of quick opening and quick closing, so it usually uses some small Flow and small pressure.Bernardo tueto,　When using the submersible slurry pump, the equipment may be burned out. The main reason for this phenomenon is improper operation. How should we prevent the burning out?　　Some corrosive pastes containing crystals can also be transported. In the application range of slurry pump, about % are used in concentrators in the mining industry. Due to the poor working conditions of primary ore dressing, the service life of slurry pump in this section is generally low. Of course, different minerals, abrasion　　The structure of the submersible slurry pump will be more intuitive. First, the equipment will use centrifugal force to drive the liquid from the impeller to the outer edge and obtain energy, and then leave the edge of the impeller at a higher speed

　　The above is the correct sequence of impeller disassembly of submersible slurry pump. Because different types of pumps have some differences in structure,　　 In addition the noise method directly detects the noise of the equipment in the detection process, but this measurement will also be affected by the surrounding noise, so in fact, this measurement is not very accurate.　　In recent years, submersible slurry pumps have replaced vertical slurry pumps. What are the differences between the two? Let&#;s yze.　　 install the front pump shaft first and then the rear bearing for the slurry pump of the filter press of the cylindrical bearing box.

　When using the submersible slurry pump, the equipment may be burned out. The main reason for this phenomenon is improper operation. How should we prevent the burning out?Marketing Department,　　After that, the secondary and tertiary pumps can be started successively until the final stage pump. After all the series pumps are started, the outlet valve of the final stage pump can be gradually opened. The speed of opening the valve should be controlled by the fact that the pump does not vibrate and the motor of any stage does not exceed the rated current.　　The inner wall is corroded and the outside air is sucked in. The pipeline pump packing is worn or the packing is not compacted.　　Sex is different. Although the submersible slurry pump is widely used,San RamonSubmersible non clogging slurry pump, the correct application is very important. Due to the limitation of the name of the slurry pump, some people outside the industry misunderstand this. In fact,San RamonPipeline pump body, the impurity pump,San RamonWQ submersible pump parameters, dredging pump, desilting pump, etc. are all in the application scope of the slurry pumpSan Ramon,　　If there are sundries blocked, the pump will not be filled with water. When this happens again, technicians need to properly adjust the liquid level in the pump sump to a proper height, and check the impeller. In case of damage or aging, it needs to be replaced in time,　　The effective power is also called output power, which is expressed by PE. It is the effective energy obtained in the pump by the medium liquid output from the pump in unit time.　　The other mechanical seal is a split seal, which can be replaced without disassembling the slurry pump.