TrutnovHorizontal wear-resistant slurry pumpWhat are the improvements in the new year

　　Then there are new structures, such as thermohydrodynamic seals, backup seals and asymmetric molded metal single wall bellows seals.　　Start the priming pump. Moreover, due to the structural limitations of the submersible slurry pump, and then the pump needs to be placed in the water for use. Therefore, the submersible slurry pump must beTrutnov,　　Submersible sewage pump the rotation direction of the electric pump after it is connected is counterclockwise from the water inlet, if the electric pump rotates Just adjust the wiring position of any two cables, and the electric pump will turn forward.　　If the shaft seal is not properly selected, it will not only require frequent maintenance during operation, but also leak a large amount of transmitted liquid.Seongnam,　　 the water pipe shall be short and the cavitation allowance of the device shall be greater than that of the pump. It is recommended to use the reverse charging installation method when transporting residues with high weight concentration.　　Submersible slurry pump is a kind of pump used in mines. Do you know the effect and form of its shaft seal? Let&#;s have a look.　　There are many types of submersible slurry pumps available in the market, and different pump models have different performance and application fields. Therefore, although the pump has a wide range of applications, if its model is not correctly and reasonably selected, its application effect will be great

　　If there are sundries blocked,TrutnovPipeline pump body, the pump will not be filled with water. When this happens again technicians need to properly adjust the liquid level in the pump sump to a proper height, and check the impeller. In case of damage or aging, it needs to be replaced in time, nor should it pump flammable liquid. How to use the submersible non clogging sewage pump?　　Let the medium containing some solid particles generate a certain flow rate, so that the equipment can drive the solid to flow when it is in use, so that the slurry can be transported. In terms of the principle of the submersible slurry pump, it is actually quite simplepacking,　　 When starting the slurry pump, the outlet gate valve shall be (closed or slightly opened by /. Before starting the slurry pump, expand the pump inlet valve and close the pump outlet valve. Then start the pump. After the pump is started, slowly start the pump outlet valve. The size and speed of opening the pump outlet valve should be based on the fact that the pump does not vibrate and the motor　　It is located in the middle, so it seems that many regions have good effects when using it.　　It needs to be replaced in case of damage, swelling and deformation, insufficient spring pressure breakage, otherwise the effect of the submersible slurry pump may not be obvious.Meticulous workmanship,　　Pressure. Therefore,TrutnovSubmersible non clogging slurry pump, a pressure gauge should be installed in this system to monitor whether the pressure meets the requirements.　　When there is glove or towel fiber in the water, there will still be stemming.　　Do not exceed the rated current.Trutnov,TrutnovDeep well submersible pump,　　 Moreover, the processes of these two pumps are also different, and the sewage pump can generally be adjusted. Submersible pumps are generally used in some special or other places.　　 In addition, the noise method directly detects the noise of the equipment in the detection process, but this measurement will also be affected by the surrounding noise, so in fact, this measurement is not very accurate.　　The packing seal, auxiliary impeller seal and mechanical seal are mainly used. Among them, the packing seal needs small leakage and is not suitable for transporting toxic, corrosive and precious liquids; The sealing of the auxiliary impeller relies on the reverse pressure of the two sealing impellers during rotation to prevent the leakage of the medium, and can also play a role in