Ceske Budejovice ISG single stage vertical pipeline pumpsupply commodity

　　.　　The submersible slurry pump may be blocked when it is used at ordinary times. In particular, some equipment is frequently used at ordinary times but the maintenance work is not done well when it is used, so it will be blocked after being used for a period of timeCeske Budejovice ,　　 There are many reasons for motor overheating. It may be because the power supply voltage is too high,Ceske Budejovice Booster pipeline pump, or there is a problem with the water pump or the motor itself.　　There is no need to equip auxiliary mixing or spraying equipment, and the operation is simpler. The equipment is directly submerged for operation, without noise and vibration, and the site is cleaner.Ngaoundere,　　Submersible slurry pump it fills the gap in the application of slurry pump. When the submergence is deep and there is no good mud outlet, that is,Ceske Budejovice Self priming slurry pump wholesale, the traditional slurry pump cannot be installed and operated, and the submersible slurry pump can supplement this part of the blank work point.　　 If the pump is equipped with a vacuum gauge or pressure gauge, open it after the speed is normal, and then gradually open the outlet sluice valve. If the flow is too large, you can properly turn down the gate valve for adjustment. Otherwise, if the flow is too small,Open the gate valve.　　 In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.

　　 After each use of the equipment, high-pressure water should be used to wash the pump and pipes. The washing can be stopped until the water has no impurities.　　Or the liquid contains fibers. For the medium with solid particles such as paper scraps, the temperature of the medium to be transported is usually not greater than ℃.　　The supply of shaft seal water must be ensured. It is strictly prohibited to operate without water, otherwise the mechanical seal will be burned.The cheapest,　　 install a valve to inject water at the water inlet and outlet. This method is to install a valve on the water inlet pipe of the submersible slurry pump and connect the water pipe to inject water into the pump. This is a common and simple method.　　Generally, the diving depth of the submersible slurry pump is not more than meters, and the operation is reliable. Why not more than meters? This is the crucial technical point of the submersible slurry pump, because the current sealing technology in China is more than meters, not because the slurry pump has a problem, but because　　 selection of flow: single suction pump or double suction pump shall be selected according to the flow; single suction pump or multi suction pump shall be selected according to the lift.

　　Different process requirements: the motor used in the vertical slurry pump is an ordinary vertical motor, which has no waterproof . The motor of the submersible slurry pump and the pump shaft are coaxial. The motor shall be waterproof and sealed. The motor and the pump body can invade underwater at the same time.Sincere service,　　 In addition the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.　　Note: Motors for special environment can be customized according to the contract.　　 Pipeline layout: Firmly support the water pipe and drain pipe to prevent the force of the pipe from acting on the submersible slurry pump.Ceske Budejovice ,　　.　　 Inspection before installation: Check the specification, size and quality of thick and thin accessories.　　When the water pump is driven by electricity or diesel engine, its impeller (like an electric fan) rotates wildly,Ceske Budejovice Single stage slurry pump, thus forming a vacuum in the impeller. In this way, from a al point of view, it is to convert electrical or chemical energy into gravity