NastoraVertical slurry pumpStandard application scope of materials

　　Avoid airborne sound transmission; Ensure the airtightness of machine room doors and windows. The water pump is equipped with a sound proof cover, and an exhaust fan is added inside the cover to ensure the ventilation of the equipment. At the same time, the inlet and outlet of the sound proof cover are equipped with silencing equipment. A vibration isolation platform is installed at the bottom of the water pump for foundation vibration reduction to isolate the vibration generated during the operation of the water pump　　If the oil seal ring of the shaft is seriously worn, replace it with a new one.Nastora,　　The development of pump industry in China has shown a very good trend in recent years. Of course,　　The type selection design of submersible slurry pump has a great impact on the service life and operation stability of slurry pump. A scientific and reasonable model selection design will affect whether your slurry pump can achieve the best efficient operation.　　How to avoid this situation when the equipment is in use.　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.

　　As an emerging product, the submersible slurry pump has many advantages, especially filling the gap in the application conditions of the traditional horizontal and vertical slurry pumps. At present, the application of the submersible slurry pump is gradually becoming more and more widespread, and the market recognition is continuously improving, especially meeting the needs of deep-water sand pumping and dredging. At present,NastoraWQ submersible pump parameters, the tape shall be stretched twice, and then the three layers shall be folded in half with PVC tape to ensure that the winding part is not less than mm,NastoraCarbon steel explosion-proof pipeline pump, and the positions of the three joints shall be staggered for a certain distance in order to prevent short circuit.Where to sell API,　　Function of shaft seal of submersible slurry pump: the main of shaft seal is to prevent high-pressure liquid from leaking out of the pump and prevent air from entering the pump.　　 It is also possible that the fan blades of the pump are few and the air volume is insufficient, resulting in poor heat dissipation effect.　　 Before starting the submersible slurry pump, the rotor of the rotating pump shall be smooth and even, the outlet sluice valve shall be closed and water shall be injected into the pump to ensure that the pump is full of water without air.

　　The production department has to spend a lot of money to maintain and update the pump every year. The pumps made of cast iron, bronze, rubber lining,NastoraFire deep well pump, stainless steel, titanium alloy and other materials used in China&#;s mining, chemical and water conservancy projects on the Yellow River are prone to wear, short service life and many faultsQuality recommendation,　　The above is a brief introduction to the effect and form of shaft seal of submersible slurry pump. Users can choose the appropriate shaft seal type according to their actual needs.　　In fact it is easy to distinguish whether a submersible sewage pump is a submersible pump or a sewage pump. A submersible sewage pump is both a submersible pump and a sewage pump, because it is designed to pump sewage or other media. Its usage is to use it in water. Both names are acceptable. When　　 When starting the slurry pump, the outlet gate valve shall be (closed or slightly opened by /. Before starting the slurry pump, expand the pump inlet valve and close the pump outlet valve. Then start the pump. After the pump is started, slowly start the pump outlet valve. The size and speed of opening the pump outlet valve should be based on the fact that the pump does not vibrate and the motorNastora,　　The utility and durability of the utility model, so the polymer composite materials are generally used in production.　　All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.　　 for screws that are too tight or rusted for a long time, the nut can be lubricated with kerosene prepared in advance, or the nut can be gently knocked with a wooden hammer and then removed. This method can also be used in slurry pumps and other places.