KauhajokiRoom wood floorAnalyze the cause of wall blistering

Moisture proof, no deformation in case of water, and can be used in kitchen, toilet, basement, etc. Rich colors and patternsKauhajoki,Fear of water and moisture: the base material of laminate floor is medium and high density board, if it is not wiped in time, it is easy to cause blistering and deformation due to water absorption and expansion. Its moisture resistance is not strong, and its stability is poor in humid environment.From to , Chinese traditional pure solid wood flooring and new solid wood flooring, which means three-layer and double-layer solid wood, have been surging in an undercurrent.In recent years, new solid wood has maintained a high annual growth rate of more than %.Under the economic development layout from to , the upgrading of solid wood flooring category caused by new solid wood will become an important driving force to promote the consumption boom of home decorative flooring.The world financial storm has an impact on China&#;s wood flooring industry chain, but it is not rampant, only lack of confidence in the market.The operation track of the development of market economy has been advancing in the cycle system of wave soldering and wave trough. The flooring industry is depressed and it is not easy to hold it for a long time. China has a strong foreign demand market,The key injury of formaldehyde is mainly manifested in the stimulation of skin and mucous membrane. Formaldehyde is a toxic chemical substance, which can fuse with protein. When inhaled at high concentration, it has serious irritation and edema of respiratory system, eye irritation and headache. Good wear resistance and stability From the characteristics of the floor it is divided into crystal surface, relief surface, latch, silent, waterproof and so on.

The flame retardant grade is B, and the formaldehyde concentration is acceptable.Precautions for solid wood floor installation : prevent uneven ground.Small blisters cannot be repaired after they are destroyed. Fire protection, fire rating B, second only to stone.Inspection standard,Floor leather (also known as coiled floor), a new type of flooring material, belongs to plastic products. It is one of the indispensable floor materials for modern room decoration. It has a thickness of more than mm and a wear-resistant layer of more than . Generally, glass wire with good flatness or double primer is used.Plastic floor leather belongs to soft floor. It is a floor roll produced by coating or calendering on sheet continuous substrate with polyvinyl chloride resin as the main raw material and appropriate additives.Advantages of floor leather Keep the floor dry and clean. If there is dirt on the floor surface, generally wipe it dry with a damp mop without dripping water.Precautions for solid wood floor installation : solid wood floor cannot be used immediately after disassembly and packaging.

The first is cleaning to remove oil stains or dust;The second is leveling. The convex part shall be shoveled and polished. The concave part can be made into paste with glue and cement at the weight ratio of :, leveled with a spatula, and then leveled with sandpaper after drying.After the ground is flat, clean and dry, it can be glued and paved.Gluing is the last process before paving, and the tool shall be a toothed rubber scraper.During gluing, glue shall be applied on the ground according to the size of the floor paint cloth, and one piece shall be paved in this order.A width of cm shall be reserved at the joint of the floor paint cloth. No glue shall be applied first, so that the joint can be treated finally.When the glue coated on the ground feels sticky by hand, it can be paved. When pasting, pay attention to aligning the sidelines, and use a long handle floor brush to blow out and compact.The joints are generally spliced by overlapping cutting, and the overlapping width is about cm.Align the long steel ruler with the center of the overlap, cut with a cutter along the ruler, then remove the cut edge strips (note that there should be two edge strips, don&#;t forget to take out the lower one), apply an appropriate amount of glue to the joint with a paint brush, and then close and compact the joint with a pressing roller.The residual glue extruded at the joint shall be wiped clean to avoid affecting the appearance.Then apply a thin layer of joint liquid along the joint.Finally, check whether there are bubbles and whether they are flat.If there are bubbles, use a syringe to insert and suck out the air, and then compact it.Finally, use washing powder to remove the residual glue marks on the lacquer cloth. If they cannot be removed, they can be wiped with alcohol.In this way, the whole process will be completed.Due to the improvement of the living standards of Chinese residents, the grade of interior decoration is also rising, and the decoration materials are increasingly developing towards the fixed decoration direction of elegance, high profile,KauhajokiDoes wooden floor contain formaldehyde, long service life and good effect.As for the ground, the service life of paint, carpet or ordinary floor leather and floor brick is not as long as that of ground lacquer cloth.Sales DepartmentThe surface layer of laminate floor is a wear-resistant layer,KauhajokiWhat board is waterproof and moisture-proof, which is composed of evenly distributed aluminum oxide,KauhajokiLaminate flooring solid wood flooring, which can achieve high hardness. Scraping with sharp hard objects such as keys can only leave very shallow traces.The pollution resistance corrosion resistance, solid wood flooring with pure natural wood is the best commodity for environmental protection. How many additives are needed for composite flooring and various index values such as indoor formaldehyde exceed solid wood flooring.The patent of the utility model is formed by cross lamination of boards of different greening plants, which gets rid of the defects of wet expansion and contraction of solid wood floor to a certain extent, has small dry shrinkage and wet expansion rate, preserves the pure natural wood texture of solid wood floor, and has comfortable feet and feet.Solid wood composite floor not only has the reliability of laminate floor and the beauty of solid wood floor, but also has the advantages of environmental protection.Fourth, it is mainly the veneer thickness (decorative board thickness). The multi-layer solid wood floor has ,-, to mm.Kauhajoki,Physical and mental health floor is the floor produced according to the production and manufacturing product quality standards and installation and application testing standards (double specifications), which is not easy to cause harmful substances and ensure the health and safety of residential gas.Second, soak in water.Fifth, smell with your nose is not protected by the environment.