BranscoISG single stage vertical pipeline pumpDigital transformation promotes high-quality development

　　The higher the specific speed of submersible slurry pump, the auxiliary impeller of the submersible slurry pump can also reduce the axial force.　　After a certain value water will also vaporize, which is called the vaporization pressure of water at this temperature.Bransco,　　In fact,BranscoLong shaft submerged slurry pump, stainless steel is not only advocated in the medical industry, but also widely used in the water pump industry. The stainless steel submersible pump of denang pump is one of them.　　For example, it has a great impact on the impeller of the equipment itself. So how to detect whether the equipment has cavitation during use?Oyugis,　　The above is the correct sequence of impeller disassembly of submersible slurry pump. Because different types of pumps have some differences in structure we also need to refer to the instructions when disassembling.　　; In practical application, the submersible slurry pump is developing rapidly with its unique advantages. The vertical slurry pump needs to be fixed and installed in use, while the submersible slurry pump can be used directly without immersion, which is convenient and flexible.　　The production department has to spend a lot of money to maintain and update the pump every year. The pumps made of cast iron,BranscoHorizontal wear-resistant slurry pump, bronze, rubber lining, stainless steel, chemical and water conservancy projects on the Yellow River are prone to wear, short service life and many faults

　　Many people do not know much about the packing and sealing of equipment because of the equipment of mass and energy. Next, let&#;s learn about the packaging and sealing method of the equipment: packing sealing is very common in submersible slurry pumps. This method has good sealing performance is easy to use, and effectively reduces the wear of the host and anti vibration kinetic energy　　Extractable.　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.Discount,　　 Structural features and working principle qsz submersible slurry pump is a coaxial integration of water pump and motor. During operation, the motor shaft drives the water pump impeller to rotate, and transmits energy to the slurry medium to generate a certain flow rate, drive the solid flow, and realize the transportation of slurry.　　 One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve, adopt the water level closed-loop control mode, install the liquid level sensor on the inner wall of the tank by the manufacturer of the slurry pump, and use the PID adjustment of the frequency converter. When　　In addition, the sundries inside the pump body and impeller shall be cleaned. Then calibrate the pump shaft and motor shaft of the slurry pump to make them on the same horizontal line.

　　Therefore, the stator winding will be burnt out due to excessive temperature rise.Customer first,　　Extend service life. In fact, the submersible slurry pump is widely used in many lives, and there is a very important component water seal in the pump, which can separate the pump body from the motor, pipe or pump body. If the current is greater than usual, we should look for problems from the wear of vulnerable parts.　　At the same time, the supporting pipelines in the pump room shall be provided with vibration isolation elasticity.Bransco,BranscoWQ submersible pump parameters,　　After that, before starting again, check whether the impeller rolling is normal and whether the bearing assembly compression bolts are tightened, and then start the pump.　　 Pipeline layout: Firmly support the water pipe and drain pipe to prevent the force of the pipe from acting on the submersible slurry pump.　　If the pressure in the local area is equal to or lower than the vaporization pressure corresponding to the water temperature in the flow process, the water will vaporize there and form many small bubbles mixed by steam and gas. The cavitation phenomenon is due to the bubble action when these small bubbles flow from the low-pressure area to the high-pressure area in the water pump,