KawaraPipeline pumpMarket share

　　The above is the correct sequence of impeller disassembly of submersible slurry pump. Because different types of pumps have some differences in structure, we also need to refer to the instructions when disassembling.　　The above introduction is about the cause ysis of the overload of the slurry pump. When we find these conditions when using the pump,KawaraCirculating hot water pipeline pump, we can check whether these reasons are the above. This is also a reminder that we need to maintain the pump during normal use. latentKawara,　　To help you solve the problem of removing the impeller of the slurry pump, we only need to fix the pump shaft and rotate the impeller in reverse to remove the impeller easily. For large pumps with impeller removal ring, we need to remove the impeller removal ring first and then rotate the impeller.　　The utility and durability of the utility model, so the polymer composite materials are generally used in production.Epe,　　 When adding lubricating oil to the pump at ordinary times, and the excess lubricating oil in the pump must be discharged and replaced regularly.　　Fourth, model selection parameters: outlet diameter, flow, dust, motor power, pumping rate, maximum particle and weight.　　There is no need to equip auxiliary mixing or spraying equipment, and the operation is simpler. The equipment is directly submerged for operation, without noise and vibration, and the site is cleaner.

　　Water flow into the bearing damages the bearing.　　In order to meet the use requirements of slurry pumps in different industrial fields and working conditions, we have continuously carried out research, development and improvement, so that we have different series,KawaraZD slurry pump, each series has a variety of specifications and models,KawaraWater well pipeline pump, and different series of products have different performance and s. Let&#;s learn about it below　　Water or air leakage in the pipeline. The nut may not be tightened during installation. If the leakage is not serious, the air or water leakage can be treated with cement or cement slurry mixed with asphalt oil. Temporary repairs can be done with some wet mud or soft soap. If water leaks at the water pump joint, tighten the nut with a wrench. asCustomer first,　　Balance of.　　The submersible slurry pump is a slurry pump which is connected with the motor and works under the water at the same time. Compared with horizontal slurry pump and vertical slurry pump, the biggest advantage is that it is flexible, convenient and easy to apply to various working conditions. The most important technical point of submersible slurry pump is the tightness between its motor and pump body Stability and reliability of seals.　　Second, the service life of the flow passage parts of the pump is relatively long, saving production costs.

　　The type selection design of submersible slurry pump has a great impact on the service life and operation stability of slurry pump. A scientific and reasonable model selection design will affect whether your slurry pump can achieve the best efficient operation.Analysis project,　　 drainage and water injection with vacuum equipment: the self exhaust of centrifugal pump is the same as the negative pressure exhaust of vacuum pump, so the water ring vacuum pump is used for exhaust to achieve the of water inlet.　　It is necessary to set up a protection system, which can protect the operation of the electric pump. But this is not the key to the problem. The protection system is just a remedy after the pump fails. It is a passive method.　　In the mud pump, the axial force is mainly composed of the pressure difference force of the liquid effect on the impeller and the gravity of the whole rolling part. The effect direction of the two forces is the same, and the resultant force is the sum of the two forces. If the submersible slurry pump is equipped with an auxiliary impeller the liquid effect is on the auxiliary impellerKawara,　　Although the shaft seal occupies a small position in the pump, and the other is to pump out the gas in the pump to establish a certain vacuum and introduce the water source.