Punta Cana Submersible slurry pumpInspection and maintenance work
In fact, the pumps I am going to talk about here have a wide range of uses. Pumps are required for both civil and military purposes, as well as for advanced technologies, especially in the mining, chemical, metallurgical and other industrial sectors. It is a widely used general mechanical equipment. Most pumps are corroded or severely corroded To repair the equipment. Submersible slurry pump is a machine used to transport liquid. It can be divided into many types according to different transport media. Then, when transporting some media with special properties, the equipment will be treated with corrosion-resistant and wear-resistant process. Only in this way can the equipment be improvedPunta Cana , (c) The minimum ambient air temperature is - ℃. the water pipe shall be short, and the cavitation allowance of the device shall be greater than that of the pump. It is recommended to use the reverse charging installation method when transporting residues with high weight concentration.Juanjui, When in use, it can drive the impeller to rotate so as to drive it to flow. Friction. Because if the surface of the pump is smooth when it is used,Punta Cana Drilling fluid slurry pump, the equipment will consume less energy when it is used. Generally, we must pay attention to reasonable design, correct calculation and appropriate type selection, which are very important. In addition to the main wheel, a set of stirring impeller is added at the bottom of the product, which can spray the precipitated slag into a mixture of water and solid particles
When this type of pump is used at ordinary times, the pump and motor operate in a coaxial whole. When it runs, the motor shaft will drive the impeller of the pump to rotate, and then at this time, the rotating force can be brought to the medium, so that Requirements for the process pretreatment unit for the normal operation of the screw pump the stator of the screw pump is generally made of rubber and the rotor is made of stainless steel. If the conveying medium contains sand particles, it will cause the Double Wear of the stator and rotor. Due to the requirements of the processing technology and materials, the Ensure that the service time will be extended when it is used. We all know that the submersible slurry pump needs to optimize its structure to meet the requirements of use because the medium it transports is relatively special. The structure has been optimized toBidding,Punta Cana Sewage pump diving, Different installation requirements: the vertical slurry pump needs to be fixed, while the submersible slurry pump does not need to be fixed. It can directly invade into the liquid for operation. Analysis of installation problems of slurry pump For bearings lubricated with thin oil, oil shall be added according to the oil level line of the oil standard before start-up. Add (HL hydraulic oil in winter and (hl hydraulic oil in summer. The bearing lubricating oil of the slurry pump shall be replaced once after continuous operation ( hours. The gas inadvertently entered in the equipment is discharged and good sealing performance is ensured.
Second the service life of the flow passage parts of the pump is relatively long, saving production costs.Total quality assurance, Commodity. Its working principle is as follows: when the screw pump is working, the liquid is sucked into the sealing cavity formed by the rotor and stator. Due to the rotation of the rotor, the liquid follows the sealing cavity to move along the axial direction from the suction side to the discharge side of the pump, and the continuous suction and discharge realize the liquid transmission . Fourth, model selection parameters: outlet diameter, flow, motor power, impeller speed, pumping rate, maximum particle and weight.Punta Cana , Then replace the pulley and pump cover plate and tighten the fixing nuts. In this way, when the equipment is used again, the solvent in the pump is often less, and the power consumption is also less and the efficiency of the pump in use is often improved, and the fact is there is also a simple method to measure the vibration frequency of the pump by vibration method. However, when using one method, there may be some errors in the measurement results. When many equipment are used there are other vibration sources that will affect the measurement results. Therefore, it is mainly