It is an auxiliary means for some on-site monitoring. Operation, maintenance and upkeep During the operation of the electric pump, always observe the current, voltmeter and water flow, and strive to make the electric pump operate under the rated working condition. Limited. According to relevant materials, the diameter of the impeller after cutting shall not be less than % of the diameter of the standard impeller, otherwise the of the pump will have a very adverse change. After the impeller of the slurry pump is cut, the flow area in the pump body increases, which makes the flow increase after the impeller is cut.offer, The non service life of the equipment is not as long as possible. If it is not used for a long time, it will not only easily corrode the parts, but also reduce the service life of the parts. Water pump After understanding the cause of insufficient liquid supply, we can solve the problem: First we need to check whether the liquid level of the circulating liquid storage tank needs to add media to it. The submersible slurry pump is a kind of submersible pump which is connected with the motor and works underwater at the same time. In addition, compared with horizontal slurry pump and vertical slurry pump,PataraSplit vertical pipeline pump, submersible slurry pump has the great advantage of flexibility and convenience,PataraSubmersible sewage pump, and is more suitable for various working conditions. The important technical points of submersible slurry pump are its motor and
It is located in the middle, so it seems that many regions have good effects when using it.Quality recommendation, What is the solution to this situation? It will also be higher, but there is no specific conversion standard. Generally speaking, the suction lift of ISG pipeline pump shall not be greater than m without adding any auxiliary equipment. .Patara The utility and durability of the utility model, so the polymer composite materials are generally used in production. Water or air leakage in the pipeline. The nut may not be tightened during installation. If the leakage is not serious, the air or water leakage can be treated with cement or cement slurry mixed with asphalt oil. Temporary repairs can be done with some wet mud or soft soap. If water leaks at the water pump joint, tighten the nut with a wrench. as If the pressure in the local area is equal to or lower than the vaporization pressure corresponding to the water temperature in the flow process, the water will vaporize there and form many small bubbles mixed by steam and gas. The cavitation phenomenon is due to the bubble action when these small bubbles flow from the low-pressure area to the high-pressure area in the water pump,