TextISG single stage vertical pipeline pumpWhere is the bottom of the fall

466HP159575805   ·  2024-05-18 03:25:36   ·   Machinery and industry equipment
accurate and reasonable selection is very important. In order to select the pump reasonably and correctly, the following aspects need to be considered: Selection of shaft seal form: shaft seal of submersible slurry pump  Water flow into the bearing damages the bearing.Text,   the experimental water shall meet the relevant process requirements.  Only in this way can its service life be extended to a large extent.Flemalle-Haute, because if the equipment is in use, it will have a great impact on the operating efficiency. Even if the cavitation time is long, it will also have a certain impact on other parts of the equipment. Sometimes submersible slurry pump  Commodity.  After that, before starting again, check whether the impeller rolling is normal and whether the bearing assembly compression bolts are tightened, and then start the pump.


TextISG single stage vertical pipeline pumpWhere is the bottom of the fall



  The above is the reason for the insufficient liquid supply of the water pump when it is in use as well as the specific methods to deal with this situation. We should pay attention to the regular inspection of the equipment during normal use to ensure that it is in use   Professional maintenance: if the submersible sewage pump cannot work normally, do not disassemble and repair it without authorization, but carry out professional maintenance immediately.  The use of water pumps for agricultural drainage and irrigation can improve the ability of agriculture to resist natural disasters, increase production and ensure income, and provide material conditions for agricultural mechanization and water conservancy.Design brand,  When this type of pump is used at ordinary times, the pump and motor operate in a coaxial whole. When it runs, the motor shaft will drive the impeller of the pump to rotate, and then at this time, the rotating force can be brought to the medium, so that  After the submersible slurry pump adds a water gun to the support at the bottom of the submersible slurry pump,TextSubmersible non clogging slurry pump, the hardened mud layer around the slurry pump will collapse rapidly under the applied water pressure, which will also increase the sand pumping area. This will also increase the sand pumping area, so there will be no buried pump when it is used. However,  Water or air leakage in the pipeline. The nut may not be tightened during installation. If the leakage is not serious, the air or water leakage can be treated with cement or cement slurry mixed with asphalt oil. Temporary repairs can be done with some wet mud or soft soap. If water leaks at the water pump joint, tighten the nut with a wrench. as


TextISG single stage vertical pipeline pumpWhere is the bottom of the fall



   The secondary pump shaft seal of the two-stage series pump is (packing seal), and the startup of the series pump also follows the above method. Only after the first stage pump is started, the submersible slurry pump can open the outlet valve of the last stage pump (the opening size is based on the motor current of the first stage pump as the rated powerGood quality,  The submersible slurry pump may be blocked when it is used at ordinary times. In particular, some equipment is frequently used at ordinary times, so it will be blocked after being used for a period of time  Fire fighting awareness is deeply rooted in the hearts of the people. With the improvement of fire fighting awareness, many people pay more and more attention to fire pumps. Some places also began to pay attention to the selection of fire pumps. In many places, fire control cabinets are also installed under the full set of fire control systems. In earlier years,TextDrilling fluid slurry pump, fire control  The motor is scrapped. Moreover, because the length of the long shaft is generally fixed the installation and use of the pump is troublesome, and the application occasions are subject to many restrictions.Text,TextRubber lining submerged slurry pump,  First the reason for the motor body: the wrong connection will make the temperature rise rapidly when the equipment is used; In addition, there may be some phase to phase short circuits between stator windings, so when the situation is relatively minor, the motor is only in local places  In order to make the equipment perform better when it is used, but this also needs to be based on its working principle. It can not be adapted at will when it is optimized.  It can also be used for cooling and lubrication. Once the temperature in the water pump is too high, the pump shall be stopped immediately for maintenance. Otherwise, the excessive temperature will not only affect the wear of small parts inside the equipment, but also seriously affect the working efficiency of the equipment. So what is the reason for the high temperature of the equipment

3 Reply   |  Until 2024-05-18 03:25:36 | 17 View

Cool Running Children's Toys Company 2024-05-18 12:29:58 Support  0 | Against  0

Cooperation with you is really good, TextISG single stage vertical pipeline pump good quality, come to our company again if you have time.

Huatiexing Vehicle Parts Company 2024-05-18 12:16:39 Support  0 | Against  0

Every time I receive the goods is very pleasant, but as long as I think of evaluating it, my head is big. Fortunately, a omnipotent friend recommended your home TextISG single stage vertical pipeline pump, the price is good, the quality is good, the delivery is good, and the boss is good.

wire mesh products 2024-05-18 12:39:51 Support  0 | Against  0

My colleagues like it very much. Come again next time. It's a rare genuine product. TextISG single stage vertical pipeline pump I'm very satisfied with it. The boss has a good personality, awesome. Not bad. The quality is good. The speed is also fast. Really good!
LoginCan Publish Content