Busgow FreiburgGrenoblereliable

When a rigid mm square or circular flat surface is applied with a normal force of N to either side of the door, the door may not meet the above requirements, but safety should be maintained.The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.Busgow Freiburg,The isolation and buffering rubber in various parts of the aluminum alloy electric elevator drive device are intact and tightly fitted.When the wall bracket adopts non matching standard products,Busgow FreiburgMesa, design calculations should be carried out.Al JizahThe landing door should meet the requirements of the specifications and achieve standardization.The net height of the landing door opening should not be less than m, and the difference between the net width and the outlet width of the cage door should not exceed mm. When the floor door is closed, except for the gap between the lower part of the door that should not exceed mm, the size of any through-hole and opening related to the distance between any door and adjacent moving parts, as well as the gap around the door or between parts,Busgow FreiburgIrish Root, should comply with the provisions of Table of 'Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas' GB-.Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.

Safety grounding device. In order to protect against electrical equipment. The metal casing of electrical equipment and the metal structure of electric elevators should be equipped with a safety grounding device. The grounding wire should operate multiple wires, and the neutral wire should not be arbitrarily held as a safety grounding wire. Its grounding resistance should not exceed ohms; The power supply of the electric elevator can be cut off.The movement of its related components is direct.The use of a lifting platform as a tool for storing performance blankets, soft scenery, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets, etc.Honest service,News Abstract: The development of the lifting platform industry will continue to grow in recent years! With the continuous development of electric lifting machinery for high-altitude operations in recent years the products of electric lifting platform vehicles have been continuously improved, and various new technologies and materials have emerged, making the further development of lifting platform vehicles possible.Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.When the landing door is closed, the full width of the lifting passage opening should be covered.

Human improper operation is the main factor causing malfunctions in scissor type electric elevators. When stacking goods, electric elevators should stack the goods neatly, which is better than stacking them in the center of the cargo stacking area of the cargo elevator to avoid imbalance between the two ends of the stacking area. Eventually, it may cause the electric elevator to lose balance. After the goods are stacked completely, ropes should be used to lock the goods, so that they are not afraid of the goods during the lifting process; Careless; Scattered downTest conclusion,Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.Limit switches should be triggered directly by the movement of the suspension cage or its related components.Pipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends,Busgow FreiburgFuli, it can automatically cut off the oil circuit and stop descentBusgow Freiburg,Manual pump: When the system malfunctions, the manual pump can be operated to pump high-pressure oil to raise the car to the nearest floor positionSpeed limiter. To prevent the driving speed from exceeding the normal speed. A speedometer should be installed (not required for floors below or including the second floor), which is an individual mechanism that is integrated with a safety clamp; The entrance and exit of the passenger compartment should be equipped with safety doors. Public places, family dormitories, andSetting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.