BarneyAh slurry pumpWhat technologies are needed for production

　　Flexibility. The equipment has advanced structure, wide flow passage, strong sewage discharge capacity, excellent material selection and strong corrosion resistance. It is suitable for conveying liquids containing solid particles, cinder and tailings. So what are the requirements for its work? Let&#;s understand briefly.　　Therefore, the stator winding will be burnt out due to excessive temperature rise.Barney,　　 WQ submersible sewage pump adopts a unique single or double vane impeller structure, which greatly improves the sewage passing capacity, and can effectively pass through times the diameter of the pump and solid particles with a diameter of about % of the diameter of the pump.　　The Tao part also consumes part of it.Rishon Leziyyon,　　Head refers to the energy obtained from the pump by the unit weight of liquid output by the pump,BarneyRubber lining submerged slurry pump, so head refers to the effective energy obtained from the liquid output by the pump in unit time - that is, the effective power of the pump: the equation is PE= ρ GQH (W)= γ QH (W)　　Troubleshooting: first increase the water pressure, then inject water into the pump body, and then start the pump. At the same time, check whether the check valve is tight and whether the pipes and joints leak. If air leakage is found, apply lubricating oil or mixed paint on the joint after disassembly,BarneyQJ submersible pump, and tighten the screws.　　 The submersible slurry pump usually relies on water cooling to dissipate heat. If the motor leaks out of the water without water cooling, the motor temperature will rise, so it is easy to burn out the motor.

　　For example, concentrate and tailings are treated in the concentrator, ash and slag are removed from the power plant, slime and dense medium coal are transported in the coal preparation plant, and slurry is transported in coastal river mining operations. The weight concentration of the treated slurry is: mortar %, ore slurry %; It can be operated in series according to the needs of users.　　Environmental conditions for normal operation of ordinary YLB motor:　　During adjustment, firstly loosen the support cover, then compress the nut, and then loosen the bearing seat. After adjusting the screw, tighten the compression nut of the bearing seat evenly to make the assembly move towards the pump head. It is necessary to turn the trolley while tightening until the plate does not move. Rotate according to the pump operationFocus on Development　　First, let&#;s talk about the familiar vertical slurry pumps. Here we refer to ZJL and SP submerged slurry pumps. Strictly speaking,BarneyCirculating hot water pipeline pump, the submersible slurry pump is also a vertical slurry pump, because its axis is basically vertical when it works, but it can be completely immersed in water when it runs, so it is a good choice　　 the submersible slag pump is often used to transport pulp containing solid particles, so the wear resistance of the pipeline should also be considered.　　When in use it can drive the impeller to rotate so as to drive it to flow.

　　In addition to the method, materials shall be selected comprehensively according to the nature of corrosive medium anti cavitation theory, corrosion mechanism of water pump and stress characteristics. In order to prolong the service life, protection should be done well, a new gasket shall be replaced. The removed parts shall be cleaned with kerosene before assembly.Barney,　　Function of shaft seal of submersible slurry pump: the main of shaft seal is to prevent high-pressure liquid from leaking out of the pump and prevent air from entering the pump.　　The slurry pump of underground pump can also work normally.　　 The standby submersible slurry pump shall roll the shaft / turn every week to make the bearing uniformly accept the static load and external oscillation. The building structure in the water pump room shall be reconstructed. Sound absorbing and isolating plates shall be installed around the wall and on the top of the machine room and fixed with light steel keel; The connecting holes between the machine room and other rooms are tightly blocked,