Havana Vertical centrifugal slurry pumpWhat is your design theory

　　 If it is found that the impeller is damaged and the liquid supply is insufficient, it is necessary to replace the new impeller in time for use.　　After that, before starting again, check whether the impeller rolling is normal and whether the bearing assembly compression bolts are tightened, and then start the pump.Havana ,　　 discharge requirements for water leakage of pump seat packing　　In order to ensure the demand for water and electricity for production and living, many units, hotels and residential areas in various provinces and cities in China have purchased it and generators. Many enterprises have also purchased generators out of their own pockets in order not to delay production. Driven by this, it and the generator naturally become popularSawakin,　　The structure of the submersible slurry pump will be more intuitive. First, the equipment will use centrifugal force to drive the liquid from the impeller to the outer edge and obtain energy, and then leave the edge of the impeller at a higher speed　　Balance of.　　Will be scrapped. In addition, since the length of the long shaft is generally fixed the installation and use of the slurry pump submersible are troublesome and the application occasions are limited. It is normal to use the equipment for a long time, for example, when the submersible slurry pump is used at ordinary times, air holes usually appear

　　Therefore,Havana Submersible sewage pump, the stator winding will be burnt out due to excessive temperature rise.　　Solution: Please fill the water source with water.　　If the shaft seal is not properly selected, it will not only require frequent maintenance during operation, but also leak a large amount of transmitted liquid.Online consultation,　　When using the submersible slurry pump, we should do a good job in all aspects of commissioning and precautions. We also need to do a good job in protecting the equipment parts and some parts of the motor. Only in this way can we avoid the impact of water and other impurities entering the motor　　Stability and reliability of seals between pump bodies.　　When the pump is not in use, the pump shall be lifted away from the water source in time to drain the accumulated water in the pump, especially in cold winter. Then put it in a dry place. Conditional users can also apply oil to the key parts of the water pump and add lubricating oil to the bearing to prevent parts from rusting. in addition

　　Submersible slurry pump it fills the gap in the application of slurry pump. When the submergence is deep and there is no good mud outlet,Havana Double suction slurry pump, that is, the traditional slurry pump cannot be installed and operated,Havana Circulating hot water pipeline pump, and the submersible slurry pump can supplement this part of the blank work point.Workshop cost,　　 important parts shall be marked in advance to avoid errors during resetting. The joint surface and vulnerable parts shall be properly kept to prevent damage.　　At this time, it is necessary to use the fire control cabinet. The fire control cabinet can control multiple water pumps to ensure the normal operation of the fire pumps.　　The supply of shaft seal water must be ensured. It is strictly prohibited to operate without water, the molecular structure of the coating itself has good compactness, which can well isolate the air, water and other media from the pump impeller during use, and also reduce the corrosion and rust as much as possible　　During the process, the equipment must be regularly maintained and overhauled to avoid blockage. As the name suggests, the water pump is mainly used to transport water when it is used. The effect of normal pumps is often better when it is used but in fact, we use it at ordinary times　　We also need to limit the starting frequency and select appropriate thermal protection devices for use.