BallinaElectric curved arm elevatorSpecify new economic coordinates

Double layer steel mesh: The diameter of the steel bars is mm, with a spacing of mm.The landing door should meet the requirements of the specifications and achieve standardization.Ballina,The shutdown device (emergency stop switch) should be non automatic reset type.It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations, making high-altitude operations easierNIM,The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of meters by meters.The pump body adopts an integrated pump station, all equipped with imported high-quality pump stations, which can also be selected according to customer requirements to meet customer ideal requirements.Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.

The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, the landing door shall not be opened.Lowering platform, vehicle mounted lifting platform, self-propelled lifting platform,BallinaAluminum alloy electric elevator, diesel engine curved arm self-propelled lifting platform, folding arm lifting platform, cylinder sleeve lifting platform aluminum alloy lifting platform, and the return oil from the lower end of the hydraulic cylinder returns to the oil tank through the balance valve and specialThe hydraulic oil enters the upper end of the hydraulic cylinder through the explosion-proof electromagnetic directional valve, hydraulic control one-way valve, throttle valve, and explosion-proof electromagnetic directional valve. To ensure a smooth descent of heavy objects and safe and reliable braking, a balance valve is installed on the return oil circuit to balance the circuit and maintain pressure, so that the descent speed does not change due to heavy objects. The throttle valve regulates the flow rate and the ascending and descending speed.Recommendation and consultation,Ballina2 meter electric lifting platform,The safety notice board for construction electric elevators should be prominently placed on the hanging cage for the rated load capacity and rated number of passengers of the construction electric elevator. It is strictly prohibited to use construction electric elevators beyond the rated load capacity or rated number of passengers.After the electric elevator passes the inspection, the user unit shall organize the leasing unit, installation unit, and supervision unit to conduct acceptance. For the implementation of construction general contracting, the acceptance shall be organized by the construction general contracting unit. The acceptance form should be signed by the relevant responsible person.The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.

Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.Energy costs, be sure to pin it tightly to prevent accidents caused by the shaft pin falling off. Hydraulic oil should be kept clean and replaced every months.The wall bracket of the construction electric elevator should be intact and reliably fixed,BallinaFixed electric hydraulic elevator, and its attachment distance, wall bracket spacing, and end height must comply with the requirements of the 'User Manual'. The angle between the plane of the wall bracket and the normal direction of the attachment surface should not exceed degrees;. When the attachment device does not meet the requirements of the 'User Manual' due to conditions, its calculation sheet, design, and production materials should be confirmed by the manufacturer or reviewed by the technical leader of the installation unit, and verified by experts.Ballina,The scaffolding of the parking platform should be laid tightly and firmly.When applying a normal force of N to any position on either side of the door using a rigid mm square or circular flat surface in the locked position of the landing door, it worked normally.The L distance depends on the selected wall mount model.