ChalcodeDiazCovarrubiasManufacturer’s wooden floorCount the highlights

The wide board specification was invented by China&#;s laminate flooring processing enterprises in order to meet consumer demand. Its advantages look generous, and there are relatively few gaps in the floor. Most of them are thickened, that is, about mm. Generally, the decorative paper on the surface is made in China, with many changes in design and color, which is more flexible. The disadvantage is that the color difference is relatively large,ChalcodeDiazCovarrubiasTen famous brands of composite solid wood flooring, and the anti ultraviolet ability of the decorative paper is poor. Produce gene mutation effect.ChalcodeDiazCovarrubias,Moreover, the formaldehyde in the floor mainly comes from the adhesives and coatings used in production.In order to improve the hardness of the board and have the effect of insect prevention and anti-corrosion, most artificial boards use urea formaldehyde resin as the adhesive. The main component is formaldehyde, and residual formaldehyde is inevitable.The environmental protection grade of domestic flooring is divided into E, E and E Only the flooring reaching grade E has a formaldehyde emission of no more than mg/l, which meets the requirements of national standards.The main raw material of SPC floor is polyvinyl chloride. Polyvinyl chloride is an environment-friendly, non-toxic and renewable resource. It has been widely used in people&#;s daily life, such as tableware and medical infusion pipe bags. Its environmental protection does not need to be worried.SPC floor (sheet) is mainly composed of natural stone powder, which does not contain any radioactive elements after testing by national authoritative departments. It is a new green and environmental protection ground decoration material.Ascension,ChalcodeDiazCovarrubiasOutdoor waterproof wood floor,For long-term indoor use, high and medium grade products should be selected, and products produced by well-known brands and regular enterprises should be purchased as far as possible. Such products have sufficient thickness and good interlayer adhesion, and are not easy to layer and curl, especially foamed leather, which gives people an elegant feeling. If you want to use them for short-term use or one-time cover, you can choose low-grade products, with poor flexibility but many of these products are processed with waste materials, generally thin thickness and large shrinkage coefficient. Laminate flooring is generally composed of four layers of composite materials, namely wear-resistant layer decorative layer, high-density substrate layer and balance (moisture proof)Laminate floor is also called impregnated paper laminated wood floor and laminate floor. Qualified laminate floor is made of one or more layers of special impregnated thermosetting amino resin.Ground lacquer cloth greenThe crystal surface is basically flat. It&#;s easy to take care of and clean up.

Structure: solid wood surface material, basic manual.With calcium carbonate as the key raw material, it is composed of PUR Crystal Shield transparent layer, wear-resistant layer, color film layer, SPC polymer plate layer, soft sound insulation and elastic layer, etc.Home decoration sales markets all over the world are very popular, which is suitable for home floor decoration.SPC floor is an economical floor material. Consumers can enjoy the texture of wood grain or stone grain in use without being bothered by noise.According to the requirements of consumers for sound insulation, blocks, plates or coils can be selected.Floor lacquer cloth, also known as floor leather (not PVC plastic floor), substation and communication room. The thickness is -mm. Other thicknesses can be made according to the needs of users. The wear-resistant layer is generally less than or equal to .mm.The choice of lacquer cloth products shall be selected according to the suitability of the site.For example, the size of the product is determined according to the space of the house and the size of the place of use.At the same time, pay attention to the different places of use, and the selected patterns should also be different.For example in places that need to be kept clean, it is not suitable to choose products with bright colors and messy.The width of coiled floor paint cloth is mm you can&#;t choose products with convex effect;In solemn places, mm and mm;The total thickness (referring to the base material, intermediate layer and surface wear-resistant layer) is divided into mm and mm;The length of each roll of floor leather is m and m.Other specifications and dimensions can be determined by the supplier and the buyer through negotiation.Because of the requirements of production, each roll of floor paint cloth is divided into several sections (the patterns between each two sections are misplaced), so the length of the small section of a roll of floor paint cloth with sections shall be indicated, and the length of the roll of floor paint cloth shall be increased by at least cm (i.e. not less than two complete patterns).Generally, there can only be one section for high-quality products, and the number of sections of each volume of first-class products and qualified products shall not exceed ;The length of each section of first-class products shall not be less than m, and the length of each section of qualified products shall not be less than m.When inspecting the appearance quality of floor paint cloth leather, it should be visually inspected obliquely under the scattered sunlight or fluorescent lamp with the illuminance of ( ± LX and LM away from the tested sample.First, observe whether there are cracks, fractures and delaminations on the surface of the floor leather. If so, it can be determined that the floor leather is unqualified.The second step is to observe whether there are wrinkle marks, bubble pollution points and pattern deformation. What cannot be observed are excellent products and first-class products;If it is slight but not obvious, it is the qualified product, otherwise it is the unqualified product.Finally, carefully check whether there is deviation during multi-color overprint on the surface, whether there are color differences in different parts, whether the superior products are uneven and if there are the above two defects, the first-class products are those with but not obvious, and the products with obvious above defects but do not affect the overall beauty are determined as qualified products.Finally, based on the above judgment, the appearance quality of ground lacquer cloth is determined.The plastic coil floor paint cloth shall roll the wear-resistant layer outward on the pipe core and shall be externally packaged.The product name, manufacturer name, product mark, grade, batch number, attention should also be paid to the physical properties when purchasing floor leather to ensure its service life.Superior quality,Look at the substrate, break the floor, and look at the substrate inside. There are no impurities in the good substrate, and the color is relatively pure. You can see a lot of impurities in the poor substrate with the naked eye.Most domestic floors use fast-growing forests and wood has been used since - years. However, imported floors, especially FSC certified plates, have strict restrictions on wood types, so wood substrates are better. Advantages. Wear resistance, wear resistance grade t.Advantages: high wear resistance, good reliability, moisture-proof, good management methods, rich and colorful color and pattern design types, and large price range.

I like to choose soft floor leatherSampling inspection,ChalcodeDiazCovarrubiasFloor protective film,For long-term indoor use, high and medium grade products should be selected, and products produced by well-known brands and regular enterprises should be purchased as far as possible. Such products have sufficient thickness and good interlayer adhesion, and are not easy to layer and curl, especially foamed leather, which gives people an elegant feeling. If you want to use them for short-term use or one-time cover, you can choose low-grade products, because the price of low-grade products is low, there are many prices to choose from, but many of these products are processed with waste materials, with poor flexibility, generally thin thickness and large shrinkage coefficient. Laminate flooring is generally composed of four layers of composite materials, namely wear-resistant layer, decorative layer, high-density substrate layer and balance (moisture proof)Laminate floor is also called impregnated paper laminated wood floor and laminate floor. Qualified laminate floor is made of one or more layers of special impregnated thermosetting amino resin. Select the content standard of dispersed formaldehyde. Do not scrape or scratch the floor surface with sharp tools.ChalcodeDiazCovarrubias,High concentration formaldehyde is a genotoxic chemical.In animal experiments, high concentration inhalation in the laboratory can cause nasopharyngeal tumors.The cross-section of the floor is rubbed with a file to generate heat in the cross-section, and formaldehyde is fully volatilized (formaldehyde is accelerated at more than degrees, and you can smell the pungent smell at the same time). At this time, you can smell, generally you can smell three different levels of smellColor film layer: various decorative layers of wood grain, stone grain and carpet grain, which can meet the different needs of different occasions and different tastes.