SpartaSmall deep well pumpComposition and function of
After meters, the sealing of the equipment can not bear the water pressure at this depth. Therefore the correct selection of shaft seal can ensure the safe and stable operation of slurry pump.Sparta, The motor ball bearing is damaged. It can also be used for cooling and lubrication. Once the temperature in the water pump is too high, the pump shall be stopped immediately for maintenance. Otherwise, the excessive temperature will not only affect the wear of small parts inside the equipment, but also seriously affect the working efficiency of the equipment. So what is the reason for the high temperature of the equipmentFlorence, Pump. In addition,SpartaIrrigation deep well pump, the submersible slurry pump is mainly characterized by 'slurry' which is wear-resistant and particle passing. When adding lubricating oil to the pump at ordinary times, the metering must be controlled, and the excess lubricating oil in the pump must be discharged and replaced regularly. It is also possible that the fan blades of the pump are few and the air volume is insufficient, resulting in poor heat dissipation effect.
if the removed gasket is seriously damaged, a new gasket shall be replaced. The removed parts shall be cleaned with kerosene before assembly. Stainless steel deep well pump can dive underground and pump hot water from deep underground. However, due to a large amount of humus and water vapor underground it is easy to adhere to the surface of various instruments and tools, resulting in rust and shortened service life. Is the stainless steel deep well pump easy to break? Use for a period of time At present, mechanical seals occupy an increasing share in the slurry pump seal market.Safety production, and conduct hydrostatic test if necessary. Moreover, the leaked flammable, explosive and toxic liquid will cause fire, explosion and poisoning, and the consequences will be unimaginable. Extend service life. In fact,SpartaVortex pump and pipeline pump, and there is a very important component water seal in the pump, which can separate the pump body from the motor, so it mainly plays a role in use
If there is abnormal sound inside the slurry pump and there is no water, it is likely that the equipment may have air infiltrating into it when absorbing water, which will cause abnormal sound inside the pump, and then at the same time, the impeller is damaged or the impeller is damagedhow, When using the sand pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, run the pump without load. Check whether the motor operates normally. During operation, be careful not to exceed the bearing on the pump support to avoid Change the oil: if the oil contains water, drain it, change the oil,SpartaSubmersible slurry pump, seal the gasket, and then tighten the screw plug. Water pump is a kind of machinery that pumps energy liquid. It is a machine that converts the mechanical energy of the prime mover into the potential energy of the pumped liquid. Driven by power machinery, it can pump liquid from low to high or far away to serve production.Sparta, Submersible slurry pump can be widely used in mining, power, metallurgy, coal, environmental protection and other industries to transport abrasive slurry containing solid particles. Such as ore slurry transportation in metallurgical concentrator, hydraulic ash removal in thermal power plant, coal slurry and heavy medium transportation in coal washing plant, river dredging, etc. In chemical industry The high-efficiency slurry pump has three characteristics: first, the slurry pump has high operation efficiency and low loss. Second, the power used is not matched, so the motor temperature will be too high after long-term overload operation; In addition, frequent startup during use will also lead to fever, so I